Parts Catalog

Full OGP Operator setup. Includes Operator, control, harnesses, arm, etc. Please note that we offer only limited tech support on installation of full operators. If you have no experience in low-energy operator installation, we rec… Read More

Control for Besam/ASSA ABLOY SW200 OGP system. Requires return of old control as core. Stock of rebuilt products is limited. If we are out of rebuilt units, you can purchase a new unit as an alternative. See part# 331008346 … Read More

Control for Besam/ASSA ABLOY SW200 OGP system. Requires return of old control as core. Stock of rebuilt products is limited. Please note that we offer only limited tech support on this item. If you have no experie… Read More

Rebuilt Besam/ASSA ABLOY SW200 operator. Requires return of old unit as core. Please note that we offer only limited tech support on this item. If you have no experience with low-energy door operators or do not fe… Read More

New Besam/ASSA ABLOY SW200 operator. Requires return of old unit as core. Please note that we offer only limited tech support on this item. If you have no experience with low-energy door operators or do not feel c… Read More

Rebuilt Record 8100 operator and control for OGP doors. Requires old unit to be returned as core. Please note that we offer only limited tech support on this item. If you have no experience with low-energy door op… Read More

New Record 8100 operator and control for OGP doors. Requires old unit to be returned as core. Please note that we offer only limited tech support on this item. If you have no experience with low-energy door operat… Read More

Besam SW200 push arm for OGP doors, Besam/Assa operator

Record, push arm for OGP systems, Record 8100 operator

The Von Duprin 22 push bar is the standard Walmart OGP push bar. Comes with alarm board (ALK). We pre-install the switch that needs to be wired into the ALK board to save you some time and avoid needing to take the bar apart to in… Read More

Von Duprin 22 panic bar with alarm board, 4ft long

Replacement end cap for Von Duprin 22 series push bars most commonly used on OGP doors. Plastic end caps that come with the bars often break and replacing with the metal version provides a more permanent solution. End caps will need to b… Read More

Replacement ALK board with face plate. Click Here for wiring diagram

ALK board for 4ft Von Duprin 22 panic bars

The HES 9600 is the standard OGP strike for Walmart stores. If you have another model, please contact us with pictures and model information if available.

OGP/ODP door timing relay, programmable delay relay

Card reader used for Online Grocery Pick-up doors.

Camden Door Controls proximity card reader for OGP doors, version 3.

Universal card reader cover for HID card readers. Used on the outside of the door to protect card reader from weather.

Tinted card reader cover. If the HID card reader is in direct sun, it can overheat. This tinted cover can help keep the reader cool.

Proximity cards for HID card readers. Comes with programming instructions. Tech support available if needed. 26 bit cards, sequentially numbered.

10 pack of key fobs for HID proximity readers

26 bit proximity cards for Camden Door Controls card reader found on many Stanley sliding doors.

10 pack of key fobs for Camden proximity readers

Key for Camden reader alarm box.

Fobster bracelet. Holds key fobs for HID or Camden readers on OGP doors. Fobs must be ordered separately.

Vinyl bottom sweeps for weather protection and pest control.  

Vinyl bottom sweeps for weather protection and pest control.

Bottom sweeps for pest control.

Bottom sweeps for pest control.

Weather seal kits for around the perimeter of a door. For other sizes and finish options, please contact us.

If an endcap is pulled off by an over-extended opening, the wire whip is usually also pulled out and is then too short. These wire whips are 18” long and provide enough slack to allow for employees over-opening the door.

18/4 wire for OGP wiring, ALK boards, Besam operators, sold per foot

18ft armor conduit for running OGP door wire up the door to protect from damage. Recommended additional part is 20ft of 18/4 wire.

VR1T Voltage Regulator for OGP, ODP doors

Power supply for mag locks, electric strikes, etc. 2 Amp, 24VDC

Safety bollard, typically used in high-wind situations for OGP doors. Blocks the door from being blown open past the hard stop.